Industrial Powerline Ethernet Bridge

               Model: WD-1201M-DIN-DC12V

System drawing and field wiring

1、Control computer
2、Switch or router
3、Powerline Ethernet Bridge（WD-1201M-DIN-DC12V）
4、Conductor rail/cable
5、Peripheral equipment
6、DC12V 1Am
7、AC85-265V

Technical parameter

Model	WD-1201M-DIN-DC12V
Interface	1*LAN 10/100/1000Base-TX self adaption RJ45，1*AC power interface MDI/MDX suppor  1*AC+PLC ,   2*DC12V
LED display light	Ethernet, PLC link ,power
Transfer frequency	2-68Mhz
Protocol（PHY）	IEEE802.3，IEEE802.3x, IEEE802.3u HomePlugAV2
Security	128-AES
Number of each group	Up to 32
installation	Rail  TS35
Protection level	IP40
Transfer rate（PHY)	1200Mbps
Modulation	OFDM
Effective transfer rate	TCP/IP  550Mbps
Manageability	Remote Firmware update，support TR-069（optional）
	802.1D Ethernet Bridge
	802.1Q VLAN
	Quality of Service(QoS)
	IGMO(IPv4)Snooping&MLD(IPv6)Snooping
Voltage range	AC 90V-265V
Output	DC12V 1A
Operating temperature	-40℃-70℃
Size	120*90*45mm（L×W×H）
Weight	0.65kg
Operating environment	Operating humidity:10%-85% (no condense)
	Storage humidity: 5%-90%(no condense)
Certification	FCC、CE class B, RoHS

Features

(1) Packet loss：≤0.1%（100M,load 70%）.
(2) Support 7*24 hours all weather operation.
(3) Hardware watch dog function.
(4) PING≤20MS.

Immunity of ESD
The testing voltage which the device should be beared: ±6kV direct Discharge, ±8kV air discharge. Discharge number in Each sensitive testing point: Plus-n-Minus 10 times each, Every time the discharge interval is 1 s, according to B/T 17626.2-2006.

Immunity of electrical fast transient impulse group(Commonmode)
The testing voltage which the device should be beared:
between the power supply voltage port and ground: ±2.0kV;
between signal circuit and ground: ±1.0kV;
repetition frequency: 5KHz, test duration: 1 min/ time;
testing times: Plus-n-Minus 5 times each. According to GB/T 17626.4-2008.

Anti interference of surge impact
The testing voltage which the device should be beared: ±2kV;
The interval of continuous impulses: 1min/time;
Test number: Plus-n-Minus 5 times each. According to GB/T 17626.5-2008.(protection: all models protection and varistor series of
discharge tube type)

Anti- vibration
Meet the demand of MX3 in TB1433(0-200Hz,2g acceleration, maximum amplitude 7mm), interface with no loose, device with no Sealing off and drop in the test

State analysis

LED Indicator description
		Ethernet	The connection between products is not established
		PLC	Whether the device is connected to other Ethernet devices
		Power	Check whether the device is powered on
Blinking indicates that the device is transmitting data

Indicator description

 

Item	Status	Description
	On	Connect the network equipment successfully
	Off	Connect the network equipment unsuccessfully
	Blinking	Begin connecting the data transmission
	On	Connect the similar equipment successfully
	Off	Connect the similar equipment unsuccessfully
	Blinking	Begin connecting the data transmission
	On	Power on
	Off	Power off